Tiger Archery Arrows SP 500: A Beginner’s Guide to Setup and Choosing Them
Learn what the Tiger Archery Arrows SP 500 are, how to match their spine and length to your bow, and how to care for them safely.
Updated November 2026
Tiger archery arrows SP 500 are a spine-rated arrow designation that tells you how stiff an arrow shaft is and how it should pair with your bow. This guide explains what the SP 500 number means, how to confirm the right fit for your draw weight and draw length, and how to keep your arrows in good shape. By the end, you will know how to check compatibility before you shoot.
What the SP 500 Rating Means
The “SP” in the name stands for spine, which is the measure of how much an arrow shaft flexes when a fixed weight is hung from its center between two supports. The number 500 refers to a standard deflection rating used by many arrow makers. A lower spine number means a stiffer shaft, and a higher number means a more flexible one. Manufacturers publish spine charts that list the recommended spine for a given bow weight and arrow length, so always check the chart for your specific model rather than relying on the number alone.
How to Check Whether SP 500 Arrows Fit Your Bow
Spine is only one part of the match. Your draw weight, draw length, point weight, and arrow length all affect how the arrow flexes when released. Start with the steps below and confirm each measurement before you buy or shoot. Tiger Archery Arrows Reviews: 3 Best Picks Compared (2026) goes further into this.
- Measure your draw length from the nock point at full draw to the grip, then add the arrow length guidance from your manufacturer’s chart.
- Note your bow’s peak draw weight, printed on the limb or in the owner’s manual.
- Choose your point weight, since heavier points stiffen the effective spine and lighter points weaken it.
- Compare these numbers against the spine chart published for the SP 500 series.
- If your bow falls between two spine ratings, consult the manufacturer or a pro shop before shooting.
Caring for and Storing Your SP 500 Arrows
Good storage keeps shafts straight and consistent, which matters for accuracy. Check each arrow for cracks, dents, or delamination before every session, and retire any that show damage. Store arrows in a rack or tube rather than leaning them against a wall, and keep them away from heat sources that can weaken adhesives. Replace nocks that loosen, and check that fletching is firmly attached.
A Simple Pre-Shoot Checklist
- Inspect each shaft for straightness and visible damage.
- Confirm all nocks are seated and tight.
- Check fletching for lifting or wear.
- Verify point weight matches the others in the set.
- Wear a bracer and finger tab to protect your arm and fingers.
Common Mistakes to Avoid
- Choosing arrows by spine number without checking your draw weight and length.
- Mixing point weights within a set, which changes flight behavior.
- Shooting a damaged shaft, since cracks can fail under load.
- Ignoring arrow length, which affects both spine and safety.
- Storing arrows in hot cars or direct sunlight, which can warp shafts over time.
Recommended Gear
A sturdy arrow bag keeps shafts protected during transport and reduces the chance of cracks from knocking against hard surfaces. View on Amazon
A digital draw scale lets you confirm your bow’s actual draw weight rather than relying on the label. View on Amazon
A fletching jig helps reattach or replace vanes evenly, which supports consistent flight. View on Amazon
For more background on arrow selection, see Archery Bow Arrows Set Guide: How to Choose the Right Setup and Safe Arrows for Archery: A Beginner's Guide to Choosing Them Right. If you are comparing other shaft options, Top 5 Practice Arrows for Archery Worth Considering in 2026 covers budget-friendly choices.
FAQ
What does SP 500 mean on archery arrows?
SP 500 is a spine rating that describes how much the shaft flexes under a standard test weight. It is used to match arrows to bows by draw weight and draw length.
How do I know if my bow needs a different spine?
Compare your peak draw weight, draw length, and point weight against the manufacturer’s spine chart. If your numbers fall between ratings, ask a qualified pro shop to confirm the match.
How often should I inspect my arrows?
Inspect them before every shooting session and after any drop or impact. Retire any shaft with cracks, dents, or loose components.
Conclusion
Tiger archery arrows SP 500 work best when the spine, length, and point weight match your bow’s draw weight and your draw length. Measure carefully, follow the manufacturer’s chart, and inspect your shafts regularly. Taking these steps will help you shoot more consistently and safely.
Ready to choose one?
